Cli-mate CLI-AP30 Dokumentacja Pobierz pdf (Strona 67)

Recommended Max. Operating Pressure

50psi / 3.5bar

Max. Operating Temperature

230°F / 110°C

Circ. Pump

Grundfos UPS 15-29 SF

Max. Flow Rate

20.5 gpm

Max. Head

9.7 ft

Flow Meter Range

0.5 – 4.0 gpm

System Voltage

120 VAC

Acceptable Fluids

Potable grade water

8.3. Unpacking

a) Pull off front insulation casing - there are no screws or clips to undo

b) Check that the box contains ALL the materials listed below. Immediately report missing or damaged

parts.

Qty

Direct Flow

Direct Flow Pump Station with Controller and Insulated Cover

Pump Station Mounting Kit

(1 x 1 3/8” Steel Sleeve)

(2 x 3” Wall Screws)

(2 x 1 1/2” Wall Screws)

(1 x 1” Wall Screws)

(4 x 1 1/2” Wall Anchors)

(4 x Washers)

Solar Controller Collector Temperature Sensor (RED)

Solar Controller Tank Temperature Sensor (Gray)

Solar Controller Data Log Kit

(1 x 1GB SD Card)

(1 x SD Card / USB Adapter)

8.4. Mounting

a) Mounting Surface: The pump station can be mounted on most wall types using the provided screws. If

building structural members are not available a wooden board or the provided hollow wall anchors should

be used to provide secure attachment points.

b) Pipe Layout: It is a good idea to layout all piping before securing the pump station in place, to make sure

that everything fits properly and sensor cables can reach the tank, etc.

c) To mount the pump station:

Step 1. Mark and drill a pilot hole for center screw.

Step 2. Mark and drill a pilot hole 6-1/4” left of center hole for controller bracket screw.

Step 3. Insert steel sleeve in insulation around center hole.

Step 4. Insert the plastic hollow wall anchors into the holes if building structural members are not

available.

Step 5. Using a Phillips head screwdriver and the appropriate screws and washers secure the pump

station to the wall.

Apricus Solar Collector Installation & Operation Manual - USA

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 119 120

Komentarze do niniejszej Instrukcji

Brak uwag

Cli-mate CLI-AP30 Dokumentacja Strona 67

Komentarze do niniejszej Instrukcji